Sadly, in this case, you need to change your connector and purchase a new one. Look if the pins are not broken, because they are delicate and a force can badly damage them. Verify that every pin in your connector is where it should be, and if not, move it there slightly. If your connector traitor is 7-pin, then the yellow wire refers to the reverse wire, while in the case of a 4-pin connector the yellow wire is for the left turn signal.Įnsure that all of them are connected rightly and tightly without any ambiguity. The most realistic solution is to replace the wires or buy new ones for the system. Your system may have been set up using the cheapest wires and cables. If the wirings are made correctly, then one or more wires may have ended up undone or the wire may have been damaged. The camera should be connected to the running lights and backup lights.Įach Furrion RV camera comes up with a manual, you can checklist all the wirings connections from that. If not, proceed to check if the wirings are connected correctly. If the connection is smooth, then start by examining the wires, if any of them had come off. Just trace the wirings from the display screen to the backup camera to see where the disconnection has occurred and repair it. Make sure that the connection between the Furrion RV backup camera and the display screen is not interrupted. The most likely cause of the “no signal” error you are experiencing with the Furrion RV camera is primarily because of the camera’s power wire. They usually occur due to poor installation, wires being twisted, damaged, or bent inaccurately. Furrion RV Camera No Signal – 5 Fixes to Try Out But recently, there has been a record of reports that the Furrion RV camera is giving no signal error! What could be the solution for this? If you’re also facing the same issue, then check out these 5 fixes to get rid of this issue.
0 Comments
Leave a Reply. |